1600 Tub Grinder

General

Length (transport): 49’8″ (15.14 m)
Length (operating): 68’10” (20.98 m)
Height: 13’6″ (4.11 m)
Width: 12′ (3.66 m)

Gross weight: 101,080 lbs. (45,850 kg)
Axle weight: 59,920 lbs. (27,180 kg)
Tongue weight: 41,160 lbs. (18,670 kg)

Engine: CAT
Horsepower: 1,050 HP to 1,200 HP (782 kW to 895 kW)

Fuel capacity (tank): 606 gallons (2,294 litres)
Hydraulic oil capacity: 328 gallons (1,242 litres)

Screen Area: 5,735 sq in (37,000 sq cm)

Discharge System

Three 16″ (40.64 cm) diameter augers discharging onto a 60″ x 34′ (152.4 cm x 10.36 m) heavy-duty conveyor. Discharge height is 18″ (45.72 cm).

Tub

Tub has 11’2″ (3.4 m) diameter at inside base, 60″ (152.4 cm) deep walls constructed of 3/8″ (9.52 mm) reinforced steel plate, and floor constructed of 1/2″ (12.7 mm) thick T-1 wear-resistant steel, supported by (16) roller guides carried on (8) 1-1/2″ (3.81 cm) diameter chrome shafts and (8) 2″ shafts.

90-degree full tilt tub for easy access to hammermill with hydraulically powered variable RPM forward and reverse tub control; Morbark Integrated Control System tub controlled with automatic reversing tub, sensor system.

Tub cover for debris containment

Engine gauge panel and emergency shut-down system.

Heavy-duty 12″ (30.48 cm) tube frame with hydraulic stabilizer legs

15′ (4.57 m) diameter opening across the top

Hammermill and Screens

43″ x 69″ (109.22 cm x 175.26 cm) hammermill opening with heavy-duty 28″ (71.12 cm) diameter rotors, (16) 1-3/8″ (3.49 cm) thick 2-piece rotor plates keyed on an 8-1/4″ (20.95 cm) diameter rotor shaft with 5-3/16″ (13.17 cm) bearings, (8) 2-1/2″ (6.35 cm) hammer retaining rods.

Hydraulic Rod Pusher

Set of two 1″ (2.54 cm) thick steel heavy-duty screens